RustPrufe Removable

Advanced Anti-Rust

Product Information
RustPrufe Advanced Anti-Rust is a temporary peelable protective coating designed to  protect steel and metal surfaces from damage caused by; flash rusting, abrasion, staining, spillage, weathering and scratching. The liquid applied coating dries to form a  tough waterproof film that will protect metal surfaces for up to 12 months. 
Material Type: Water based.
Clear. Also available in any colour pigment upon request. 
Health & Safety:
The compound is non-toxic and non-flammable in the wet state. The dry film waste may be disposed of as low hazard. 
Please see separate Material Safety Data Sheet (MSDS)
Shelf life 24 months. Store at temperatures between 5°C - 25°C.
Steel, metals and other porous surfaces.
Rust Inhibitor: RustPrufe has been formulated to include a flash rush inhibitor.

Application Information
The contents of the container should be mixed thoroughly before use. Always conduct a  test area and a test peel on each substrate before use. 
A minimum wet film thickness (WFT) of 250 Microns [100 Microns dry film thickness (DFT)] must be achieved, anything less may result in the product becoming  difficult to remove. Do not apply in wet or freezing conditions and protect from rainfall.
By Spray:
Apply with airless spray gun, using a 17 thou tip size and a box coat to achieve a minimum WFT of 250 Microns (100 Microns DFT).
By Lambswool Roller – Apply 2 coats, allowing 1st to tack off. Apply generously to  achieve a minimum WFT of 250 Microns (100 Microns DFT).
Tack Free Drying Time:
A WFT of 250 Microns will be tack free in approximately 120 minutes at room temperature. Force drying may be used by using moving air and increasing the surface temperature to a maximum of 50°C.
The theoretical coverage rate is approximately 5m2 per kg at a WFT of 250 Microns. 
Removal: The dry film can be easily removed either by hand peeling or by pressure hose. Do not  remove in freezing conditions as the coating may be brittle.
Weather Resistance:
RustPrufe is suitable for up to 12 months UV exposure. 
Clean Down:
Clean rollers and equipment with water immediately after use.
Repair: If the protective coating rips, repair by lifting the ripped patch and apply a fresh coat to  the underside and reseal. Alternatively, cut away the damaged area and apply a fresh coat.
Technical Information
Tensile Strength: >5 MPa
Viscosity: 18000 ± 2000 cP @ 20°C
Solids Content: 45 ± 2 %
Elongation: >1000 %
Flash Point: N/A
Adhesion: < 1.0 MPa
Density: 1.09 kgl-1 Maximum VOC: 80 gl-1 pH: 7-8




Technologies We Use

  • seal saver

  • turbowerx

  • Oil Watch

  • ATS Electrolube